DTC U0433:00 [SKYACTIV-D 1.5]

id0102q2901700

DTC U0433:00

Abnormal message from laser sensor

DETECTION CONDITION

•  Correct data cannot be received for 5 s from laser sensor.

Diagnostic support note

•  This is an intermittent monitor (other).

•  The check engine light does not illuminate.

•  FREEZE FRAME DATA is not available.

•  Snapshot data is available.

•  DTC is stored in the PCM memory.

FAIL-SAFE FUNCTION

•  Not applicable

POSSIBLE CAUSE

•  Laser sensor malfunction

SYSTEM WIRING DIAGRAM

•  Not applicable

DTC U0433:00	Abnormal message from laser sensor
DETECTION CONDITION	• Correct data cannot be received for 5 s from laser sensor. Diagnostic support note • This is an intermittent monitor (other). • The check engine light does not illuminate. • FREEZE FRAME DATA is not available. • Snapshot data is available. • DTC is stored in the PCM memory.
FAIL-SAFE FUNCTION	• Not applicable
POSSIBLE CAUSE	• Laser sensor malfunction
SYSTEM WIRING DIAGRAM	• Not applicable

Diagnostic Procedure

STEP	INSPECTION		ACTION
1	RECORD VEHICLE STATUS AT TIME OF DTC DETECTION TO UTILIZE WITH REPEATABILITY VERIFICATION Note • Recording can be facilitated using the screen capture function of the PC. • Record the snapshot data on the repair order.	—	Go to the next step.
2	VERIFY RELATED SERVICE INFORMATION AVAILABILITY • Verify related Service Information availability. • Is any related Service Information available?	Yes	Perform repair or diagnosis according to the available Service Information. • If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	VERIFY LASER SENSOR DTC • Switch the ignition off. • Perform the laser sensor DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSIS [LASER SENSOR].) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSIS [LASER SENSOR].) Go to the next step.
3		No	Go to the next step.
4	VERIFY DTC TROUBLESHOOTING COMPLETED • Always reconnect all disconnected connectors. • Clear the DTC from the PCM memory using the M-MDS. (See CLEARING DTC [SKYACTIV-D 1.5].) • Perform the DTC Reading Procedure. (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-D 1.5].) • Is the same DTC present?	Yes	Replace the laser sensor, then go to the next step. (See LASER SENSOR REMOVAL/INSTALLATION.)
4		No	Go to the next step.
5	VERIFY AFTER REPAIR PROCEDURE • Perform the “AFTER REPAIR PROCEDURE”. (See AFTER REPAIR PROCEDURE [SKYACTIV-D 1.5].) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [SKYACTIV-D 1.5].)
5		No	DTC troubleshooting completed.