QUICK RELEASE CONNECTOR (EMISSION SYSTEM) REMOVAL/INSTALLATION [SKYACTIV-D 1.5]

id0116q2805500

Fuel Tank Type B Only

Caution

•  Foreign material on the connecting area of the quick release connector might cause damage to the connector or evaporative hose. To prevent this, clean the connecting area before reconnecting a disconnected connector.

Quick release connector position

am3zzw00017944

Removal

Caution

•  Be careful not to damage the evaporative pipe when unlocking the retainer.

Note

•  If the quick release connector is removed, replace the retainer with a new one.

1.  Set the finger parallel to the quick release connector.

am3zzw00017945

Note

•  The quick release connector can be removed by pushing the end of the retainer.

•  The retainer is attached to the evaporative pipe even after the connector is disconnected.

2.  Hold the end of the retainer with the finger and press the retainer.

3.  Pull the connector side and disconnect the quick release connector.

4.  Cover the disconnected quick release connector and evaporative pipe with vinyl sheeting or a similar material to prevent it from getting scratched or dirty.

Installation

Note

•  If the quick release connector O-ring is damaged or has slipped, replace the quick release connector.

am3zzw00017946

1.  Inspect the evaporative hose and evaporative pipe sealing surface for damage and deformation.

•  If there is any malfunction, replace it with a new one.

2.  Apply a small amount of clean engine oil to the sealing surface of the evaporative pipe.

3.  Insert the hose to the end of nipple of the quick release connector.

4.  Insert the quick release connector onto pipe until retainer is locked.

5.  Lightly pull and push the quick release connector a few times by hand, and then verify that it is connected securely.

6.  Make certain that workers shall not touch retainer.