CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION [MZR 1.6]

id0140j7800600

Caution

•  When replacing the CKP sensor, make sure there is no foreign matter on it such as metal shavings. If it is installed with foreign matter, the sensor output signal will malfunction resulting from fluctuation in magnetic flux and cause a deterioration in engine control.

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [MZR 1.6].)

2.  Lift up the vehicle.

3.  Perform the following procedure for easier access.

(1)  Remove the front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)

(2)  Remove the front splash shield (RH). (See SPLASH SHIELD REMOVAL/INSTALLATION.)

4.  Disconnect the CKP sensor connector.

5.  Remove the CKP sensor.

am3zzw00014150

6.  Install in the reverse order of removal.