ENGINE OIL PRESSURE SENSOR INSPECTION [SKYACTIV-D 1.5]

id0140q2216900

Voltage Inspection

Note

•  The engine oil temperature sensor and engine oil pressure sensor cannot be removed as a single unit. When replacing the engine oil temperature sensor or engine oil pressure sensor, replace the engine oil temperature sensor/engine oil pressure sensor. (See ENGINE OIL TEMPERATURE SENSOR/ENGINE OIL PRESSURE SENSOR REMOVAL/INSTALLATION [SKYACTIV-D 1.5].)

1.  Switch the ignition ON (engine off).

2.  Measure the voltage at the engine oil temperature sensor/engine oil pressure sensor terminal D.

am3zzw00017809

•  If the voltage is within the specification, go to the next step.

•  If the voltage is not within the specification, replace the engine oil temperature sensor/engine oil pressure sensor. (See ENGINE OIL TEMPERATURE SENSOR/ENGINE OIL PRESSURE SENSOR REMOVAL/INSTALLATION [SKYACTIV-D 1.5].)

3.  Connect the M-MDS to the DLC-2.

4.  Start the engine.

5.  Access the PID/DATA monitor item EOP using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-D 1.5].)

6.  Measure the voltage at the engine oil temperature sensor/engine oil pressure sensor terminal D when the EOP PID increases.

•  If the voltage does not increase, replace the engine oil temperature sensor/engine oil pressure sensor. (See ENGINE OIL TEMPERATURE SENSOR/ENGINE OIL PRESSURE SENSOR REMOVAL/INSTALLATION [SKYACTIV-D 1.5].)

Specification (Reference)

am2zzw00011365