CLUTCH STROKE SENSOR INSPECTION [SKYACTIV-D 1.5]

id0140q2889000

Voltage Inspection

Note

• The clutch stroke sensor cannot be removed as a single unit. When replacing the clutch stroke sensor, replace it together with the clutch master cylinder as a single unit.

1. Connect the M-MDS to the DLC-2.

2. Switch the ignition ON (engine off).

3. Verify that the voltage at clutch stroke sensor terminal B when the clutch pedal is depressed/released is as indicated in the following table:

am3zzw00017824

Clutch pedal position

Voltage (V)

Clutch pedal released

Approx. 0.6

Clutch pedal depressed

Approx. 4.5

Clutch pedal position	Voltage (V)
Clutch pedal released	Approx. 0.6
Clutch pedal depressed	Approx. 4.5

• If not as verified, replace the clutch master cylinder. (See CLUTCH MASTER CYLINDER REMOVAL/INSTALLATION [D66M-R].) (See CLUTCH STROKE SENSOR REMOVAL/INSTALLATION [D66M-R].)

Specification (Reference)

am2zzw00011439