CRANKSHAFT POSITION (CKP) SENSOR INSPECTION [SKYACTIV-D 2.2]
id0140z7800500
Visual Inspection
-
Caution
-
• When replacing the CKP sensor, make sure there is no foreign matter on it such as metal shavings. If it is installed with foreign matter, the sensor output signal will malfunction resulting from fluctuation in magnetic flux and cause a deterioration in engine control.
1. Turn the steering wheel to full right lock.
2. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)
3. Lift up the vehicle.
4. Remove the front splash shield (RH). (See SPLASH SHIELD REMOVAL/INSTALLATION.)
5. Disconnect the CKP sensor connector.
6. Remove the CKP sensor. (See CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)
7. Verify that there are no metal shavings on the CKP sensor.
-
• If there is a malfunction, remove any metal shavings that are adhering.
Voltage Inspection
-
Caution
-
• When replacing the CKP sensor, make sure there is no foreign matter on it such as metal shavings. If it is installed with foreign matter, the sensor output signal will malfunction resulting from fluctuation in magnetic flux and cause a deterioration in engine control.
• If the wiring harnesses or waterproof connectors are damaged, water penetrating the connector will cause a sensor malfunction. To prevent this, be careful not to damage wiring harnesses or waterproof connectors.
1. Idle the engine.
2. Measure the CKP sensor output voltage wave pattern using an oscilloscope.
-
-
• Specification
-
4.5 V or more (Maximum value of wave pattern)
0.8 V or less (Minimum value of wave pattern)
Wave pattern (reference)
Oscilloscope setting
-
• 3 V/DIV (Y), 1 ms/DIV (X), DC range
Vehicle condition
-
• Idle after warm up
