EGR VALVE POSITION SENSOR INSPECTION [SKYACTIV-D 2.2]

id0140z7807600

Voltage Inspection

Note

•  Because the EGR valve position sensor is integrated in the EGR valve, replacing the EGR valve position sensor includes replacement of the EGR valve.

1.  Switch the ignition ON (engine off).

2.  Measure the voltage at the EGR valve/EGR valve position sensor terminal D.

am3zzw00016129

•  If the voltage is within the specification, go to the next step.

•  If the voltage is not within the specification, replace the EGR valve. (See EGR VALVE REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

3.  Connect the M-MDS to the DLC-2.

4.  Start the engine.

5.  Access the PID/DATA monitor item EGRP_ACT and simulation item EGRP using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-D 2.2].)

6.  Verify that the EGRP_ACT monitor value conforms to the EGRP monitor value when the simulation item EGRP is set from 0 % to 80 %.

•  If not as verified, replace the EGR valve. (See EGR VALVE REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

Specification (Reference)

ac5wzw00004494