CLUTCH STROKE SENSOR INSPECTION [SKYACTIV-D 2.2]

id0140z7889000

Voltage Inspection

Note

•  The clutch stroke sensor cannot be removed as a single unit. When replacing the clutch stroke sensor, replace it together with the clutch master cylinder as a single unit.

1.  Connect the M-MDS to the DLC-2.

2.  Switch the ignition ON (engine off).

3.  Verify that the clutch stroke sensor output voltage (PID: CPP) within the specification. (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-D 2.2].) (See PCM INSPECTION [SKYACTIV-D 2.2].)

•  If not as specified, replace the clutch master cylinder. (See CLUTCH MASTER CYLINDER REMOVAL/INSTALLATION [D66M-R].)