DTC P2855:00 [FW6A-EL]

id050225578600

DTC P2855:00

Low clutch hydraulic circuit/sealing malfunction

DETECTION CONDITION

•  Slow engaging after operating selector lever from N to D position.

FAIL-SAFE FUNCTION

Not applicable

POSSIBLE CAUSE

•  Low clutch piston sealing malfunction

•  Seal ring poor functioning

•  ATF is less than specified value

SYSTEM WIRING DIAGRAM

Not applicable

DTC P2855:00	Low clutch hydraulic circuit/sealing malfunction
DETECTION CONDITION	• Slow engaging after operating selector lever from N to D position.
FAIL-SAFE FUNCTION	Not applicable
POSSIBLE CAUSE	• Low clutch piston sealing malfunction • Seal ring poor functioning • ATF is less than specified value
SYSTEM WIRING DIAGRAM	Not applicable

Diagnostic procedure

STEP	INSPECTION		ACTION
1	INSPECT ATF LEVEL • Inspect the ATF level. (See AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION [FW6A-EL].) • Is there any malfunction?	Yes	Adjust the ATF level to the specification, then go to the next step. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [FW6A-EL].)
1		No	Replace the automatic transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [FW6A-EL].)
2	VERIFY DTC TROUBLESHOOTING COMPLETED • Perform the following procedure to ensure that the DTC has been resolved: 1. Verify that the ATF temperature is 30 °C {86 °F} or more. 2. Perform the following operation 20 times. ― Operate the selector lever from N to D position and wait for 5 s or more. ― Operate the selector lever from D to N position and wait for 5 s or more. • Clear the DTC using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [FW6A-EL].) • Perform the DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [FW6A-EL].) • Is the DTC P2855:00 also present?	Yes	Replace the automatic transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [FW6A-EL].)
2		No	DTC troubleshooting completed.