DTC P0716:00 [FW6A-EL]

id050225904000

DTC P0716:00

Turbine/input shaft speed sensor range/performance problem
DETECTION CONDITION
•  Under the following condition, the turbine/input shaft speed is 9,000 rpm or more for 1 s:
―  Battery voltage is 8 V or more.
FAIL-SAFE FUNCTION
•  Set to TCC control.
•  Inhibits learning control.
•  Inhibits manual mode.
•  Inhibits neutral idle control.
•  Inhibits i-stop control.
•  Inhibits AAS.
•  Inhibits 5GR and 6GR.
•  Inhibits shift down when the accelerator pedal is depressed.
POSSIBLE CAUSE
•  Turbine/input shaft speed sensor malfunction
SYSTEM WIRING DIAGRAM
Not applicable

Diagnostic procedure

STEP

INSPECTION

ACTION
1
RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
Note
•  Recording can be facilitated using the screen capture of the PC function.
•  Record the freeze frame data/snap shot data.
—
Go to the next step.
2
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
•  Verify related Service Information availability.
•  Is any related Service Information available?
Yes
Perform repair or diagnosis according to the available Service Information.
•  If the vehicle is not repaired, replace the control valve body.
Go to the next step.
No
Replace the control valve body, then go to the next step.
(See CONTROL VALVE BODY REMOVAL/INSTALLATION [FW6A-EL].)
3
VERIFY DTC TROUBLESHOOTING COMPLETED
•  Clear the DTC using the M-MDS.
•  Perform the following procedure to ensure that the DTC has been resolved:
1.  Drive the vehicle for 1 s or more under the following condition:
•  Vehicle speed: 30 km/h {19 mph} or more
•  Perform the DTC inspection using the M-MDS.
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [FW6A-EL].)
No
DTC troubleshooting completed.