TRANSAXLE RANGE (TR) SWITCH INSPECTION [FN4A-EL]

id051701291800

Caution

•  Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.

Operation Inspection

1.  Perform the following procedures to inspect the TR switch.

•  If there is any malfunction, adjust the TR switch. (See TRANSAXLE RANGE (TR) SWITCH ADJUSTMENT [FN4A-EL].)

(1)  Verify that the starter operates only when the ignition is switched to START with the selector lever in P or N position.

(2)  Verify that the back-up lights illuminate when selected to R position with the ignition at ON.

(3)  Verify that the positions of the selector lever and the selector indicator light are aligned.

On-Vehicle Inspection

1.  Perform the following procedures.

(1)  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [MZR 1.6].)

(2)  Remove the front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)

(3)  Disconnect the TR switch connector.

am3zzw00007383

2.  Inspect continuity as indicated in the table.

am3uuw00002405

am3uuw00002406

•  If there is any malfunction, adjust the TR switch. (See TRANSAXLE RANGE (TR) SWITCH ADJUSTMENT [FN4A-EL].)