INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION [FN4A-EL]

id051701292600

Caution

•  Always use a new bolt. If the removed input/turbine speed sensor installation bolt is reused, it may cause oil leakage.

•  A sealant coating is applied to the input/turbine speed sensor installation bolt to prevent oil leakage from the installation bolt hole which passes through the component.

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [MZR 1.6].)

2.  Remove in the order indicated in the table.

am3zzw00007387

1	Connector
2	Input/turbine speed sensor
3	O-ring

3.  Install in the reverse order of removal.