ON/OFF SOLENOID REMOVAL/INSTALLATION [EW6A-EL]

id0517l2117100

Warning

•  A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool.

•  Always wear protective eye wear when using the air compressor. If the air compressor is used, any particles of dirt or sludge could spatter and get into the eyes.

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 1.5].)

2.  Remove the front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)

3.  Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents.

4.  Drain the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [EW6A-EL].)

5.  Remove the oil pan.

Note

•  Always use new oil pan installation bolts when re-installing the oil pan because the oil pan installation bolts cannot be reused.

6.  Disconnect the ON/OFF solenoid connector.

Note

•  Disconnect the ON/OFF solenoid connector by pressing the connector tab with your fingers.

am3uuw00008388

7.  Remove the ON/OFF solenoid.

am3uuw00008389

8.  Install the ON/OFF solenoid.

am3uuw00008389

9.  Connect the ON/OFF solenoid connector.

am3uuw00008388

10.  Apply a light coat of silicone sealant (TB1217E or equivalent) to the contact surfaces of the oil pan and transaxle case.

am3uuw00008281

Caution

•  Clean any remaining silicone sealant on the contact surface of the transaxle case and oil pan, and degrease the sealant area. Otherwise, oil could leak.

11.  Install the oil pan with new bolts before the applied sealant starts to harden.

am6zzw00012181

12.  Add the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [EW6A-EL].)

13.  Connect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 1.5].)

14.  Perform the “Mechanical System Test”. (See MECHANICAL SYSTEM TEST [EW6A-EL].)

15.  Install the front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)