PID/DATA MONITOR TABLE [INSTRUMENT CLUSTER]
id0902e8960700
|
PID |
Unit/Operation |
Data contents |
Module control terminal |
|---|---|---|---|
|
AFS_ST*1
|
Off/On
|
• Off: AFS not operated
• On: AFS operated
|
B, D (CAN)
|
|
AT_MAN_M_SW*2
|
Off/On/Unknown
|
• Off: M position switch is off.
• On: M position switch is on.
• Unknown: M position switch signal is not determined.
|
H (M position switch signal)
|
|
AT_S_DWN_SW*2
|
Off/On/Unknown
|
• Off: Down switch is off.
• On: Down switch is on.
• Unknown: Down switch signal is not determined.
|
G (Down switch signal)
|
|
AT_S_UP_SW*2
|
Off/On/Unknown
|
• Off: Up switch is off.
• On: Up switch is on.
• Unknown: Up switch signal is not determined.
|
F (UP switch signal)
|
|
BSM/RVM_SW*3
|
Off/On
|
With blind spot monitoring (BSM) system
• Off: BSM OFF switch is off.
• On: BSM OFF switch is on.
With rear vehicle monitoring system
• Off: RVM switch is off.
• On: RVM switch is on.
|
T, V (BSM OFF/RVM switch operation signal)
|
|
DSC_OFF_SW*4
|
Off/On
|
• Off: DSC OFF switch is off.
• On: DSC OFF switch is on.
|
T, V (DSC OFF switch operation signal)
|
|
FUEL_GAUGE
|
L
|
Displays fuel level detected by the fuel gauge
|
—
|
|
FUEL_SEN_M
|
ohm*9/V*10
|
Fuel gauge sender unit connector 4-pin type
• Displays fuel gauge sender unit resistance value
Fuel gauge sender unit connector 5-pin type
• Displays fuel gauge sender unit voltage value
|
—
|
|
FUEL_SEN_S
|
ohm*9/V*10
|
|
—
|
|
I_ILLUMI_M
|
Off (Day)/On (Night)
|
• Off (Day): TNS switch is off.
• On (Night): TNS switch is on.
|
B, D (CAN)
|
|
I-ST_OFF_SW*5
|
Off/On
|
• Off: i-stop OFF switch is off.
• On: i-stop OFF switch is on.
|
T, V (i-stop OFF switch operation signal)
|
|
LDWS_ON_SW*6
|
Off/On
|
• Off: LDWS switch is off.
• On: LDWS switch is on.
|
T, V (LDWS switch operation signal)
|
|
MULTI_SW_ST
|
O.K./FAULT
|
• O.K.: Cluster switch is normal.
• FAULT: Cluster switch is malfunctioning.
|
T, V (Cluster switch operation signal)
|
|
ODO_CNT
|
km, ft, mi
|
Displays rolling count of the odometer
|
—
|
|
P_BRAKE_SW
|
Off/On
|
• Off: Parking brake not applied
• On: Parking brake applied
|
X (Parking brake switch signal)
|
|
R_GEAR_SW
|
Off/On
|
ATX
• Displays in the M-MDS but it does not operate.
MTX
• Off: Back-up light switch is off.
• On: Back-up light switch is on.
|
B, D (CAN)
|
|
R_LMP
|
Off/On/Unknown/Fault
|
• Off: Back-up light is turned off.
• On: Back-up light is turned on.
• Unknown: Back-up light signal is not determined.
• Fault: Back-up light malfunction
|
B, D (CAN)
|
|
SPEEDOMTR
|
KPH, MPH
|
Displays vehicle speed (100 %=300 km/h {186 mph})
|
—
|
|
TACHOMTR*7
|
RPM
|
Displays engine speed (100 %=10,000 rpm)
|
—
|
|
TOTAL_TIME
|
hh:mm:ss
|
Displays cumulative elapsed time since vehicle completion
|
—
|
|
TPMS_CAL_SW*8
|
Off/On
|
• Off: Tire pressure monitoring system (TPMS) set switch is off.
• On: Tire pressure monitoring system (TPMS) set switch is on.
|
T, V (Tire pressure monitoring system (TPMS) set switch status signal)
|
|
VPWR
|
V
|
Displays power supply voltage
|
S, U (Power supply)
|