DTC B1D19:98 [CONNECTIVITY MASTER UNIT]

id0902n7091200

Description

Abnormal CD player or DVD/CD player temperature

Detection condition

•  With the ignition switched ON (engine off or on), the connectivity master unit (CMU) detects an abnormally high temperature condition in the CD player or DVD/CD player.

Fail-safe function

CD/DVD playback stopped.

Possible cause

Caution

•  If the CD player or DVD/CD player is used for long periods in a hot environment, the temperature of the CD player or DVD/CD player will increase and a DTC may be output. The CD player or DVD/CD player should not be used continuously for long periods with the cabin under high temperature conditions from being left under direct sunlight.

•  Temperature increase due to continuous use for long periods.

•  CD player or DVD/CD player malfunction

System wiring diagram

Not applicable

Description	Abnormal CD player or DVD/CD player temperature
Detection condition	• With the ignition switched ON (engine off or on), the connectivity master unit (CMU) detects an abnormally high temperature condition in the CD player or DVD/CD player.
Fail-safe function	CD/DVD playback stopped.
Possible cause	Caution • If the CD player or DVD/CD player is used for long periods in a hot environment, the temperature of the CD player or DVD/CD player will increase and a DTC may be output. The CD player or DVD/CD player should not be used continuously for long periods with the cabin under high temperature conditions from being left under direct sunlight. • Temperature increase due to continuous use for long periods. • CD player or DVD/CD player malfunction
System wiring diagram	Not applicable

Diagnostic Procedure

Step	Inspection		Action
1	VERIFY IF CD PLAYER OR DVD/CD PLAYER TEMPERATURE WAS TEMPORARILY HIGH • Clear the DTC for the connectivity master unit (CMU) using the M-MDS. (See CLEARING DTC [CONNECTIVITY MASTER UNIT].) • Switch the ignition ON (engine off or on) and wait for 7 s or more. • Perform the DTC inspection for the connectivity master unit (CMU) using the M-MDS. (See DTC INSPECTION [CONNECTIVITY MASTER UNIT].) • Is the same DTC displayed?	Yes	Leave the vehicle in a cool location for 30 min or more, then go to the next step.
1		No	Go to Step 3.
2	VERIFY THAT REPAIRS HAVE BEEN COMPLETED • Clear the DTC for the connectivity master unit (CMU) using the M-MDS. (See CLEARING DTC [CONNECTIVITY MASTER UNIT].) • Switch the ignition ON (engine off or on) and wait for 7 s or more. • Perform the DTC inspection for the connectivity master unit (CMU) using the M-MDS. (See DTC INSPECTION [CONNECTIVITY MASTER UNIT].) • Is the same DTC displayed?	Yes	Replace the CD player or DVD/CD player, then go to the next step. (See CD PLAYER REMOVAL.) (See CD PLAYER INSTALLATION.) (See DVD/CD PLAYER REMOVAL.) (See DVD/CD PLAYER INSTALLATION.)
2		No	Go to the next step.
3	VERIFY OTHER DTCs • Are any other DTCs displayed?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [CONNECTIVITY MASTER UNIT].)
3	VERIFY OTHER DTCs • Are any other DTCs displayed?	No	DTC troubleshooting completed.