i-stop OFF SWITCH INSPECTION [SKYACTIV-D 1.5]

id0140q2888900

Note
•  The i-stop OFF switch is integrated with the cluster switch.
•  If the i-stop OFF switch is to be replaced, replace the cluster switch. (See CLUSTER SWITCH REMOVAL/INSTALLATION.)

Resistance Inspection

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 1.5].)

2.  Remove the cluster switch. (See CLUSTER SWITCH REMOVAL/INSTALLATION.)

3.  Measure the resistance between cluster switch terminals B and C under the following conditions.

Resistance with i-stop OFF switch pressed and held
•  83.66—85.34 ohms
Resistance with any switch not pressed
•  1,139.99—1,163.01 ohms
am3zzw00017822
•  If not within the specification, replace the cluster switch. (See CLUSTER SWITCH REMOVAL/INSTALLATION.)


LED Illumination Inspection

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 1.5].)

2.  Remove the cluster switch. (See CLUSTER SWITCH REMOVAL/INSTALLATION.)

3.  Apply battery positive voltage to cluster switch terminal J, and connect terminal I to ground.

am3zzw00017823

4.  Verify that the LED is turned on.

•  If the LED does not turn on, replace the cluster switch. (See CLUSTER SWITCH REMOVAL/INSTALLATION.)