DTC C0010:01/C0011:01/C0014:01/C0015:01/C0018:01/C0019:01/C001C:01/C001D:01 [ANTILOCK BRAKE SYSTEM (ABS)]
id0402b0877200
|
DTC
|
C0010:01
|
LF inlet solenoid valve system
|
|
|
C0011:01
|
LF outlet solenoid valve system
|
||
|
C0014:01
|
RF inlet solenoid valve system
|
||
|
C0015:01
|
RF outlet solenoid valve system
|
||
|
C0018:01
|
LR inlet solenoid valve system
|
||
|
C0019:01
|
LR outlet solenoid valve system
|
||
|
C001C:01
|
RR inlet solenoid valve system
|
||
|
C001D:01
|
RR outlet solenoid valve system
|
||
|
DETECTION CONDITION
|
• Malfunction detected in the ABS HU/CM solenoid valve or internal circuit by the ABS HU/CM on-board diagnostic function
|
||
|
FAIL-SAFE FUNCTION
|
• Illuminates the ABS warning light and brake system warning light.
• Inhibits the ABS and EBD controls.
|
||
|
POSSIBLE CAUSE
|
• Open or short circuit in the ABS HU/CM internal solenoid valves
• Solenoid valve malfunction
|
||
|
SYSTEM WIRING DIAGRAM
|
Not applicable
|
||
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY SOLENOID VALVE OPERATION
• Switch the ignition to off.
• Connect the M-MDS to the DLC-2.
• Switch the ignition ON (engine off).
• Access the active command mode for the solenoid valve using the M-MDS.
• Does the solenoid valve operate?
|
Yes
|
Go to the next step.
|
|
No
|
Replace the ABS HU/CM, then go to the next step.
|
||
|
2
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Clear the DTC from the memory.
• Start the engine and drive the vehicle at 10 km/h {6.2 mph} or more.
• Gradually slow down and stop vehicle.
• Are the same DTCs present?
|
Yes
|
Repeat the inspection from Step 1.
If the malfunction recurs, replace the ABS HU/CM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY AFTER REPAIR PROCEDURE
• Are any other DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||