DTC C1031:41 [DYNAMIC STABILITY CONTROL (DSC)]
id0402b2906700
|
DTC
|
C1031:41
|
Tire pressure monitoring system (TPMS) system
|
|
|
DETECTION CONDITION
|
• When the DSC HU/CM detects malfunction in the memory for storing a calculated tire pressure value.
|
||
|
FAIL-SAFE FUNCTION
|
• Tire pressure monitoring system warning light illuminates after flashes.
• Inhibits the TPMS control.
|
||
|
POSSIBLE CAUSE
|
• DSC HU/CM internal error
• DSC HU/CM malfunction
|
||
|
SYSTEM WIRING DIAGRAM
|
—
|
||
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
INITIALIZE A TPMS MEMORY
• Switch the ignition to off.
• Connect the M-MDS (IDS) to DLC-2.
• After the vehicle is identified, select the following items from the initial screen of the IDS.
• Perform the procedure according to the directions on the screen.
• Is the initialization normally completed?
|
Yes
|
Go to the next step.
|
|
No
|
Repeat the inspection from Step 1.
If the malfunction recurs, replace the DSC HU/CM, then go to the next step.
|
||
|
2
|
VERIFY THAT THE SAME DTC IS NOT PRESENT
• Clear the DTCs from the memory.
• Are the same DTCs present?
|
Yes
|
Repeat the inspection from Step 1.
If the malfunction recurs, replace the DSC HU/CM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY THAT NO OTHER DTCS ARE PRESENT
• Are any other DTCs output?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||