REAR BRAKE (DISC) REMOVAL/INSTALLATION

id041100800500

Caution

• The rear brake hose gasket has been established as a specialized part. If a gasket other than the specialized part is used, it could result in brake fluid leakage. Therefore, always use the specialized gasket for the rear brake hose.

Note

• Verify the shape of the caliper shown in the figure to determine type A or B.

am3zzw00015897

1. Remove in the order indicated in the table.

2. Install in the reverse order of removal.

3. After installation, add brake fluid, bleed the air, and inspect for fluid leakage. (See BRAKE FLUID AIR BLEEDING.)

4. Pump the brake pedal a few times and inspect the following:

― The disc pad projection is securely installed to the piston groove

― Parking brake lever stroke

― Brake drag

REAR CALIPER TYPE A

am3zzw00020477

1

Rear parking brake cable

(See Rear Parking Brake Cable Installation Note.)

2

Bolt

3

Brake hose

4

Bolt

5

Caliper

(See Caliper Installation Note.)

6

Disc pad

7

Shim

8

Guide plate

9

Bolt

10

Mounting support

11

Slide pin

12

Dust boot

13

Disc plate

REAR CALIPER TYPE B

am3zzw00020478

Caliper Installation Note

1. Clean the exposed area of the piston.

2. Rotate the piston clockwise slowly using the SST and push the piston completely until the piston grooves are in the position shown in the figure.

am3zzw00015898

3. Install the caliper.

Rear Parking Brake Cable Installation Note

1. Install the rear parking brake cable to the rear caliper.

2. Verify that the outer end tabs of the rear parking brake cable is securely engaged with the bracket.

am3uuw00010922

1	Rear parking brake cable (See Rear Parking Brake Cable Installation Note.)
2	Bolt
3	Brake hose
4	Bolt
5	Caliper (See Caliper Installation Note.)
6	Disc pad
7	Shim
8	Guide plate
9	Bolt
10	Mounting support
11	Slide pin
12	Dust boot
13	Disc plate