FRONT ABS WHEEL-SPEED SENSOR REMOVAL/INSTALLATION

id041500800300

1. Remove the mudguard. (See MUDGUARD REMOVAL/INSTALLATION.)

2. Remove in the order indicated in the table.

3. Install in the reverse order of removal.

4. After installation, verify that there is no twisting in the front ABS wheel-speed sensor.

ac5wzw00007125

Front ABS Wheel-speed Sensor Wiring Harness and Clip Disconnection Note

Note

• Refer to this note only if the disconnection of the front ABS wheel-speed sensor wiring harness and the clip shown in the figure is required.

ac5wzw00007126

1. Insert a flathead screwdriver from the side where there is no notch as shown in the figure.

ac5wzw00007127

2. Detach the tab as shown in the figure and disconnect the ABS wheel-speed sensor wiring harness and clip.

ac5wzw00007128

1	Connector
2	Bolt
3	Front ABS wheel-speed sensor (See Front ABS Wheel-speed Sensor Wiring Harness and Clip Disconnection Note.)