DTC: 26:Er83 [AUDIO]
id0902f6037100
|
Description |
Microphone circuit malfunction |
|---|---|
|
Detection condition
|
Short to ground in microphone power supply circuit
|
|
Fail-safe function
|
Not applicable
|
|
Possible cause
|
• Connector or terminal malfunction
• Short to ground in wiring harness between the following terminals:
• Microphone malfunction
• Bluetooth® unit malfunction
|
 |
|
Diagnostic Procedure
|
Step |
Inspection |
Action |
|
|---|---|---|---|
|
1
|
INSPECT MICROPHONE CONNECTOR CONDITION
• Switch the ignition off.
• Disconnect the negative battery cable.
• Disconnect the microphone connector.
• Inspect the connector for poor connection (such as damaged/pulled-out pins, and corrosion).
• Is there any malfunction?
|
Yes
|
Repair or replace the connector or terminal, then go to Step 5.
|
|
No
|
Go to the next step.
|
||
|
2
|
INSPECT Bluetooth® UNIT CONNECTOR CONDITION
• Disconnect the Bluetooth® unit connector.
• Inspect the connector for poor connection (such as damaged/pulled-out pins, and corrosion).
• Is there any malfunction?
|
Yes
|
Repair or replace the connector or terminal, then go to Step 5.
|
|
No
|
Go to the next step.
|
||
|
3
|
INSPECT MICROPHONE POWER SUPPLY CIRCUIT FOR SHORT TO GROUND
• Inspect for continuity between the following terminals (vehicle wiring harness) and body ground:
• Is there continuity?
|
Yes
|
If there is a common connector:If there is no common connector:
Refer to the wiring diagram and verify whether or not there is a common connector between Bluetooth® unit terminal C and microphone terminal C.
• Determine the malfunctioning part by inspecting the common connector and the terminal for corrosion, damage, or pin disconnection, and the common wiring harness for a short to ground.
• Repair or replace the malfunctioning part.
• Repair or replace the wiring harness which has a short to ground.
Go to Step 5.
|
|
No
|
Go to the next step.
|
||
|
4
|
INSPECT Bluetooth® UNIT POWER SUPPLY CIRCUIT
• Make sure reconnect the disconnected connectors.
• Connect the negative battery cable.
• Switch the ignition ON (engine off or on).
• Measure the voltage at the following terminal (vehicle wiring harness):
• Is there any voltage?
|
Yes
|
Replace the microphone, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
5
|
VERIFY TROUBLESHOOTING COMPLETED
• Clear the DTC from the Bluetooth® unit memory.
(See CLEARING DTC [AUDIO].)
• Perform the Bluetooth® unit DTC inspection.
(See DTC INSPECTION [AUDIO].)
• Is the same DTC present?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the Bluetooth® unit.
Go to the next step.
|
|
No
|
Go to the next step.
|
||
|
6
|
VERIFY THAT NO OTHER DTCs ARE RECORDED
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [AUDIO].)
|
|
No
|
DTC troubleshooting completed.
|
||