DTC U3000:01 [BLIND SPOT MONITORING (BSM)]

id0902i3393200

Description

Electrical malfunction inside BSM control module

Detection condition

•  BSM control module is detected an electrical malfunction inside.

Fail-safe function

•  Blind spot monitoring (BSM) system is stopped.

Possible cause

•  BSM control module malfunction

System wiring diagram

Not applicable

Description	Electrical malfunction inside BSM control module
Detection condition	• BSM control module is detected an electrical malfunction inside.
Fail-safe function	• Blind spot monitoring (BSM) system is stopped.
Possible cause	• BSM control module malfunction
System wiring diagram	Not applicable

Diagnostic Procedure

Step	Inspection		Action
1	PERFORM DTC INSPECTION AND VERIFY BSM CONTROL MODULE MALFUNCTION • Clear the DTC for the BSM control module using the M-MDS. (See CLEARING DTC [BLIND SPOT MONITORING (BSM)].) • Retrieve the BSM control module DTCs using the M-MDS. (See DTC INSPECTION [BLIND SPOT MONITORING (BSM)].) • Is the same DTC displayed?	Yes	Replace the BSM control module, then go to the next step. (See BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION.)
1		No	Go to the next step.
2	VERIFY IF OTHER DTCs DISPLAYED • Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [BLIND SPOT MONITORING (BSM)].)
2		No	DTC troubleshooting completed.