STEERING ANGLE SENSOR INSPECTION

id091800813400

Note

•  If the steering angle sensor is removed from the clock spring, the steering angle sensor absolute angle could change, therefore, do not remove the steering angle sensor from the clock spring.

•  If the steering angle sensor is replaced, replace it together with the clock spring. (See CLOCK SPRING REMOVAL/INSTALLATION.)

1.  Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION.)

2.  Connect the plus (+) end of a tester to steering angle sensor terminal A and the minus (-) end of the tester to terminal B (ground).

am6zzw00008110

3.  Switch the ignition ON (engine off or on).

4.  Turn the steering wheel to the right and left.

5.  Verify that the voltage between steering angle sensor terminals A and B (ground) is as indicated in the table.

am3uuw00010496

•  If the voltage can be verified as indicated in the table, go to the next step.

•  If not as indicated in the table, replace the clock spring. (See CLOCK SPRING REMOVAL/INSTALLATION.)

6.  Switch the ignition off.

7.  Connect the plus (+) end of a tester to steering angle sensor terminal C and the minus (-) end of the tester to terminal B (ground).

8.  Switch the ignition ON (engine off or on).

9.  Turn the steering wheel to the right and left.

10.  Verify that the voltage between steering angle sensor terminals C and B (ground) is as indicated in the table.

am3uuw00010497

•  If not as indicated in the table, replace the clock spring. (See CLOCK SPRING REMOVAL/INSTALLATION.)