DTC P05A0:00 [SKYACTIV-G 1.5, SKYACTIV-G 2.0, SKYACTIV-G 2.5]

id0102h9402200

DTC P05A0:00

Active air shutter: Opening angle abnormality (sticking)
DETECTION CONDITION
•  Active air shutter opening angle is certain value or less while intake air temperature is 5 °C {41 °F} or more.
Diagnostic support note
•  This is a continuous monitor (other).
•  The check engine light does not illuminate.
•  PENDING CODE is available if the PCM detects the above malfunction condition during first drive cycle.
•  FREEZE FRAME DATA (Mode 2) is not available.
•  Snapshot data is available.
•  DTC is stored in the PCM memory.
FAIL-SAFE FUNCTION
•  Performs fully open/closed position learning function three times.
POSSIBLE CAUSE
•  Foreign matter caught in active air shutter
•  Active air shutter malfunction
•  PCM malfunction
SYSTEM WIRING DIAGRAM
Not applicable

Diagnostic Procedure

STEP

INSPECTION

ACTION
1
VERIFY FREEZE FRAME DATA (MODE 2)/SNAPSHOT DATA HAS BEEN RECORDED
•  Has the FREEZE FRAME DATA (Mode 2)/snapshot data been recorded?
Yes
Go to the next step.
No
Record the FREEZE FRAME DATA (Mode 2)/snapshot data on the repair order, then go to the next step.
2
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
•  Verify related Service Information availability.
•  Is any related Service Information available?
Yes
Perform repair or diagnosis according to the available Service Information.
•  If the vehicle is not repaired, go to the next step.
No
Go to the next step.
3
VERIFY IF DIAGNOSTIC RESULT IS AFFECTED BY DTC RELATED TO ACTIVE AIR SHUTTER
•  Switch the ignition off, then ON (engine off).
•  Perform the Pending Trouble Code Access Procedure and DTC Reading Procedure.
•  Is the PENDING CODE/DTC U0284:00 also present?
Yes
Go to the applicable PENDING CODE or DTC inspection.
(See DTC U0284:00 [SKYACTIV-G 1.5, SKYACTIV-G 2.0, SKYACTIV-G 2.5].)
No
Go to the next step.
4
VERIFY IF FOREIGN MATTER IS LODGED
•  Verify if the active air shutter has lodged foreign matter.
•  Has the active air shutter lodged any foreign matter?
Yes
Remove the foreign matter, then go to Step 6.
No
Go to the next step.
5
INSPECT ACTIVE AIR SHUTTER
•  Inspect the active air shutter.
•  Is there any malfunction?
Yes
Replace the active air shutter, then go to the next step.
(See ACTIVE AIR SHUTTER REMOVAL/INSTALLATION.)
No
Go to the next step.
6
VERIFY DTC TROUBLESHOOTING COMPLETED
•  Always reconnect all disconnected connectors.
•  Clear the DTC from the PCM memory using the M-MDS.
•  Start the engine.
•  Drive the vehicle at 10 km/h {6.2 mph} or more for approx. 1 min.
•  Perform the Pending Trouble Code Access Procedure.
•  Is the PENDING CODE and/or DTC for this DTC present?
Yes
Repeat the inspection from Step 1.
•  If the malfunction recurs, replace the PCM.
Go to the next step.
No
Go to the next step.
7
VERIFY AFTER REPAIR PROCEDURE
•  Perform the “AFTER REPAIR PROCEDURE”.
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [SKYACTIV-G 1.5, SKYACTIV-G 2.0, SKYACTIV-G 2.5].)
No
DTC troubleshooting completed.