WHEEL HUB COMPONENT REMOVAL/INSTALLATION

id031200800400

Caution

•  Performing the following procedures without first removing the rear ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the rear ABS wheel-speed sensor connector (body side) and fix the wiring harness to an appropriate place where it will not be pulled by mistake while servicing the vehicle.

1.  When working on the left side of the vehicle, remove the auto leveling sensor from the rear lower arm. (With headlight auto leveling system) (See AUTO LEVELING SENSOR REMOVAL/INSTALLATION.)

2.  Remove in the order indicated in the table.

3.  Install in the reverse order of removal.

4.  Inspect the rear wheel alignment. (See REAR WHEEL ALIGNMENT.)

am3zzw00015843

1	Rear ABS wheel-speed sensor
2	Brake hose clip
3	Brake caliper component (See Brake Caliper Component Removal Note.)
4	Disc plate
5	Bolt (wheel hub)
6	Wheel hub
7	Dust cover
8	Dynamic damper (vehicles with dynamic damper)
9	Rear stabilizer control link lower nut
10	Rear lower arm outer bolt (See Rear Lower Arm Outer Bolt Removal Note.)
11	Rear coil spring (See REAR COIL SPRING REMOVAL/INSTALLATION.)
12	Rear shock absorber lower nut (See REAR SHOCK ABSORBER REMOVAL/INSTALLATION.)
13	Stud bolt (See REAR SHOCK ABSORBER REMOVAL/INSTALLATION.)
14	Rear lateral link outer bolt (See REAR LATERAL LINK REMOVAL/INSTALLATION.)
15	Rear trailing link installation bolt (See REAR LATERAL LINK REMOVAL/INSTALLATION.)
16	Rear upper arm outer bolt
17	Hub support
18	Wheel hub bolt (See Wheel Hub Bolt Removal Note.) (See Wheel Hub Bolt Installation Note.)
19	Hub support bushing (front) (See Hub Support Bushing (Front) Removal Note.) (See Hub Support Bushing (Front) Installation Note.)
20	Hub support bushing (rear) (See Hub Support Bushing (Rear) Removal Note.) (See Hub Support Bushing (Rear) Installation Note.)

Brake Caliper Component Removal Note

1.  Remove the brake caliper component from the trailing link and suspend it out of the way using a cable.

Rear Lower Arm Outer Bolt Removal Note

1.  Support the rear lower arm using a jack.

am3uuw00009882

2.  Remove the rear lower arm outer bolt.

Wheel Hub Bolt Removal Note

Note

•  Remove the wheel hub bolt only if there is any malfunction.

1.  Remove the wheel hub bolt using a press.

am3uuw00009883

Hub Support Bushing (Front) Removal Note

1.  Mark the hub support as shown in the figure.

am3uuw00009884

2.  Press the rear hub support bushing (front) out using the SSTs.

am3uuw00009885

Hub Support Bushing (Rear) Removal Note

1.  Mark the hub support as shown in the figure.

am3uuw00009886

2.  Press the rear hub support bushing (rear) out using the SSTs.

am3uuw00009887

Hub Support Bushing (Rear) Installation Note

1.  Align the projection of the bushing with the hub support marking and set a new bushing to the hub support.

am3uuw00009888

2.  Install a new hub support bushing (rear) using the SSTs.

am3uuw00009889

Hub Support Bushing (Front) Installation Note

1.  Align the projection of the bushing with the hub support marking and set a new bushing to the hub support.

am3uuw00009890

2.  Install a new hub support bushing (front) using the SSTs.

am3uuw00009891

Wheel Hub Bolt Installation Note

1.  Install the new wheel hub bolt using a press.

am3uuw00009892