DTC U0336:00 [DYNAMIC STABILITY CONTROL (DSC)]
id0402b2860900
|
DTC
|
U0336:00
|
Abnormal message from SAS control module
|
|
|
DETECTION CONDITION
|
• Correct data cannot be received from SAS control module.
|
||
|
FAIL-SAFE FUNCTION
|
• Illuminates the TCS/DSC indicator light.
• Inhibits the Secondary Collision Reduction (SCR) control.
|
||
|
POSSIBLE CAUSE
|
• SAS control module malfunction
|
||
|
SYSTEM WIRING DIAGRAM
|
Not applicable
|
||
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
PERFORM SAS CONTROL MODULE DTC INSPECTION
• Switch the ignition to off.
• Verify DTCs for the SAS control module using the M-MDS.
(See DTC INSPECTION.)
• Is the DTC displayed?
|
Yes
|
Repair the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE)
|
|
No
|
Go to the next step.
|
||
|
2
|
VERIFY THAT THE SAME DTC IS NOT PRESENT
• Clear DTC for the DSC HU/CM using the M-MDS.
• Are the same DTCs present?
|
Yes
|
Repeat the inspection from Step 1.
If the malfunction recurs, replace the SAS control module, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY IF OTHER DTCs DISPLAYED
• Are any other DTCs displayed?
|
Yes
|
Repair the malfunctioning part according to the applicable DTC troubleshooting.
|
|
No
|
DTC troubleshooting completed.
|
||