DTC C1031:35 [DYNAMIC STABILITY CONTROL (DSC)]

id0402b2906600

DTC
C1031:35
Tire pressure monitoring system (TPMS) set switch
DETECTION CONDITION
•  Continuous ON signal from the TPMS set switch for 60 s or more is detected.
FAIL-SAFE FUNCTION
•  Tire pressure monitoring system warning light illuminates after flashes.
•  Inhibits the TPMS control.
POSSIBLE CAUSE
•  The driver pressed and held the TPMS set switch for 60 s or more.
•  TPMS set switch malfunction
SYSTEM WIRING DIAGRAM
Not applicable

Diagnostic procedure

STEP

INSPECTION

ACTION
1
VERIFY DTCs FOR INSTRUMENT CLUSTER
•  Switch the ignition to off.
•  Using the M-MDS, perform the DTC inspection for the instrument cluster.
•  Are any DTCs detected?
Yes
Go to applicable DTC inspection.
(See DTC TABLE [INSTRUMENT CLUSTER].)
No
Go to the next step.
2
INSPECT TPMS SET SWITCH
•  Inspect the TPMS set switch.
•  Is the TPMS set switch normal?
Yes
Go to the next step.
No
Replace the TPMS set switch, then go to the next step.
(See TIRE PRESSURE MONITORING SYSTEM SET SWITCH REMOVAL/INSTALLATION.)
3
VERIFY THAT THE SAME DTC IS NOT PRESENT
•  Reconnect all disconnected connectors.
•  Clear the DTCs from the memory.
•  Are the same DTCs present?
Yes
Repeat the inspection from Step 1.
No
Go to the next step.
4
VERIFY THAT NO OTHER DTCS ARE PRESENT
•  Are any other DTCs output?
Yes
Go to the applicable DTC inspection.
(See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)].)
No
DTC troubleshooting completed.