DTC P0883:00 [EW6A-EL]

id050234820100

DTC P0883:00

TCM power supply voltage high

DETECTION CONDITION

•  TCM power supply voltage is 18 V or more for 5 s.

FAIL-SAFE FUNCTION

•  Set to emergency mode.

•  Inhibits learning control.

•  Inhibits manual mode.

•  Inhibits neutral idle control.

•  Inhibits i-stop control.

•  Inhibits AAS.

POSSIBLE CAUSE

•  PCM DTC is stored.

•  Battery malfunction

•  Generator malfunction

SYSTEM WIRING DIAGRAM

Not applicable

DTC P0883:00	TCM power supply voltage high
DETECTION CONDITION	• TCM power supply voltage is 18 V or more for 5 s.
FAIL-SAFE FUNCTION	• Set to emergency mode. • Inhibits learning control. • Inhibits manual mode. • Inhibits neutral idle control. • Inhibits i-stop control. • Inhibits AAS.
POSSIBLE CAUSE	• PCM DTC is stored. • Battery malfunction • Generator malfunction
SYSTEM WIRING DIAGRAM	Not applicable

Diagnostic procedure

STEP	INSPECTION		ACTION
1	RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION Note • Recording can be facilitated using the screen capture of the PC function. • Record the freeze frame data/snap shot data.	—	Go to the next step.
2	VERIFY RELATED SERVICE INFORMATION AVAILABILITY • Verify related Service Information availability. • Is any related Service Information available?	Yes	Perform repair or diagnosis according to the available Service Information. • If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	VERIFY PCM DTC • Perform the PCM DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-D 1.5].) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [SKYACTIV-D 1.5].)
3		No	Go to the next step.
4	INSPECT BATTERY • Inspect the battery. (See BATTERY INSPECTION [SKYACTIV-D 1.5].) • Is there any malfunction?	Yes	Replace the battery, then go to Step 6. (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-D 1.5].)
4		No	Go to the next step.
5	INSPECT GENERATOR • Inspect the generator. (See GENERATOR INSPECTION [SKYACTIV-D 1.5].) • Is there any malfunction?	Yes	Replace the generator, then go to the next step. (See GENERATOR REMOVAL/INSTALLATION [SKYACTIV-D 1.5].)
5		No	Go to the next step.
6	VERIFY DTC TROUBLESHOOTING COMPLETED • Clear the DTC using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [EW6A-EL].) • Perform the following procedure to ensure that the DTC has been resolved: 1. Switch the ignition ON (engine off or on) and wait for 5 s or more. • Perform the DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [EW6A-EL].) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [EW6A-EL].)
6		No	DTC troubleshooting completed.