SHROUD UPPER MEMBER REMOVAL/INSTALLATION

id091000889800

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 1.5, SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [MZR 1.6].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)(See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 1.5].)

2.  Remove the following parts:

(1)  Set plate (See SET PLATE REMOVAL/INSTALLATION.)

(2)  Front bumper (See FRONT BUMPER REMOVAL/INSTALLATION.)

(3)  Front combination light (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION.)

(4)  Horn (See HORN REMOVAL/INSTALLATION.)

3.  Remove the wiring harness clip shown in the figure. (with DSC)

am3uuw00011663

4.  Remove the bolt shown in the figure and set the body ground aside.

am3uuw00011664

5.  Remove the bolts shown in the figure and remove the shroud upper member in the direction of the arrow.

am3uuw00011665

6.  Install in the reverse order of removal.

7.  Adjust the headlight aiming. (See HEADLIGHT AIMING.)