KEYLESS RECEIVER INSPECTION

id091400514400


4SD

1.  Remove the following parts:

(1)  Rear seat cushion (See REAR SEAT CUSHION REMOVAL/INSTALLATION.)
(2)  Rear seat back (See REAR SEAT BACK REMOVAL/INSTALLATION.)
(3)  Rear scuff plate (RH) (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)
(4)  Tire house trim (RH) (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)
(5)  C-pillar trim (RH) (See C-PILLAR TRIM REMOVAL/INSTALLATION.)

2.  Remove the keyless receiver with the connector still connected. (See KEYLESS RECEIVER REMOVAL/INSTALLATION.)

3.  Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).

•  If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s) and related wiring harnesses.
―  If the system does not operate normally even though the parts under Inspection Item(s) and related wiring harnesses do not have any malfunction, replace the keyless receiver.


Terminal Voltage Table (Reference)

ac5jjw00000234

Terminal

Signal name

Connected to

Measurement conditions

Voltage (V)

Inspection item(s)
A
Power supply
Start stop unit
Under any condition
Approx. 5
Start stop unit
B
DATA
Start stop unit
Because this terminal is for communication, determination using terminal voltage inspection is not possible.
Start stop unit
D
GND
Body ground
Under any condition
1.0 or less
Ground


5HB

1.  Remove the following parts:

(1)  Trunk covering (See TRUNK COVERING REMOVAL/INSTALLATION.)
(2)  Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION.)
(3)  Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)
(4)  Rear seat cushion (See REAR SEAT CUSHION REMOVAL/INSTALLATION.)
(5)  Rear seat back (See REAR SEAT BACK REMOVAL/INSTALLATION.)
(6)  Rear scuff plate (RH) (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)
(7)  Tire house trim (RH) (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)
(8)  Rear package tray (See REAR PACKAGE TRAY REMOVAL/INSTALLATION.)
(9)  Trunk side upper trim (RH) (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION.)
(10)  C-pillar trim (RH) (See C-PILLAR TRIM REMOVAL/INSTALLATION.)

2.  Remove the keyless receiver with the connector still connected. (See KEYLESS RECEIVER REMOVAL/INSTALLATION.)

3.  Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).

•  If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s) and related wiring harnesses.
―  If the system does not operate normally even though the parts under Inspection Item(s) and related wiring harnesses do not have any malfunction, replace the keyless receiver.


Terminal Voltage Table (Reference)

ac5jjw00000234

Terminal

Signal name

Connected to

Measurement conditions

Voltage (V)

Inspection item(s)
A
Power supply
Start stop unit
Under any condition
Approx. 5
Start stop unit
B
DATA
Start stop unit
Because this terminal is for communication, determination using terminal voltage inspection is not possible.
Start stop unit
D
GND
Body ground
Under any condition
1.0 or less
Ground