INTRUDER SENSOR INSPECTION

id091400517300

1. Remove the front map light. (See FRONT MAP LIGHT REMOVAL/INSTALLATION.)

2. Remove the intruder sensor with the connector connected. (See INTRUDER SENSOR REMOVAL/INSTALLATION.)

3. Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).

• If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s) and related wiring harnesses.

― If the system does not operate normally even though the parts under Inspection Item(s) and related wiring harnesses do not have any malfunction, replace the intruder sensor.

Terminal Voltage Table (Reference)

ac5wzw00002764

Terminal

Signal name

Connected to

Measurement condition

Voltage (V)

Inspection item (s)

B

Ground

Rear body control module (RBCM)

Under any condition

1.0 or less

Rear body control module (RBCM)

C

DATA

Rear body control module (RBCM)

Because this terminal is for communication, determination using terminal voltage inspection is not possible.

D

Power supply

Rear body control module (RBCM)

Under any condition

B+

Rear body control module (RBCM)

Terminal	Signal name	Connected to	Measurement condition	Voltage (V)	Inspection item (s)
B	Ground	Rear body control module (RBCM)	Under any condition	1.0 or less	Rear body control module (RBCM)
C	DATA	Rear body control module (RBCM)	Because this terminal is for communication, determination using terminal voltage inspection is not possible.
D	Power supply	Rear body control module (RBCM)	Under any condition	B+	Rear body control module (RBCM)

Continuity Inspection Of Short Wiring Harness Connector

1. Verify that the continuity is as indicated in the table.

am3zzw00014664

• If not as indicated in the table, replace the short wiring harness.