DC-DC CONVERTER (i-ELOOP) INSPECTION [i-ELOOP]

id131704010000

1.  Verify that the DC-DC converter (i-ELOOP) related DTC is detected. (See DTC INSPECTION [i-ELOOP].) (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 1.5, SKYACTIV-G 2.0, SKYACTIV-G 2.5].)

•  If DTCs are detected, repair the malfunctioning part according to the applicable DTC troubleshooting.

•  If a DTC is not detected, go to the next step.

2.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 1.5, SKYACTIV-G 2.0, SKYACTIV-G 2.5].)

3.  Disconnect the service plug. (See SERVICE PLUG DISCONNECTION/CONNECTION [i-ELOOP].)

4.  Remove the front seat component (LH). (See FRONT SEAT REMOVAL/INSTALLATION.)

5.  Remove the DC-DC converter (i-ELOOP) cover. (See DC-DC CONVERTER (i-ELOOP) REMOVAL/INSTALLATION [i-ELOOP].)

6.  Do a visual inspection of the DC-DC converter (i-ELOOP).

•  If the DC-DC converter (i-ELOOP) is damaged, replace it. (See DC-DC CONVERTER (i-ELOOP) REMOVAL/INSTALLATION [i-ELOOP].)

7.  Install in the reverse order of removal.