REAR OIL SEAL REPLACEMENT [SKYACTIV-D 2.2]

id0110s5800900

1.  Remove the transaxle. (See MANUAL TRANSAXLE REMOVAL/INSTALLATION [D66M-R] (MTX).) (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [GW6A-EL] (ATX).)

2.  Remove the flywheel (MTX) or the drive plate (ATX). (See CLUTCH UNIT REMOVAL/INSTALLATION [D66M-R] (MTX).) (See DRIVE PLATE REMOVAL/INSTALLATION [GW6A-EL] (ATX).)

3.  Remove in the order indicated in the table.

4.  Install in the reverse order of removal.

ac5wzw00004957

1	Rear oil seal (See Rear Oil Seal Removal Note.) (See Rear Oil Seal Installation Note.)

Rear Oil Seal Removal Note

1.  Cut the oil seal lip using a utility knife.

2.  Remove the oil seal using a flathead screwdriver with the tip protected by a clean cloth to prevent damage to the oil seal sliding part of the crankshaft.

ac5wzw00004958

Rear Oil Seal Installation Note

1.  Apply clean engine oil to the inner surface of a new rear oil seal.

2.  Insert the rear oil seal into the cylinder block by hand.

3.  Tap the oil seal in evenly using the SST and a hammer.

ac5wzw00005234

ac5wzw00005277