DTC C0062:28/C0062:64 [ANTILOCK BRAKE SYSTEM (ABS)]

id0402b0108200

DTC

C0062:28, C0062:64

SAS control module system

DETECTION CONDITION

Note

•  The low-G sensor and the yaw rate sensor are built into the SAS control module.

•  Out-of-specification signal modulation or longitudinal-G value is detected from the low-G sensor.

FAIL-SAFE FUNCTION

Not applicable

POSSIBLE CAUSE

•  SAS control module malfunction

•  ABS HU/CM malfunction

•  Poor connection at connectors (female terminal)

SYSTEM WIRING DIAGRAM

Not applicable

Diagnostic procedure

STEP	INSPECTION		ACTION
1	INSPECT SAS CONTROL MODULE MALFUNCTION • Switch the ignition to off. • Using the M-MDS, perform the DTC inspection for the SAS control module. (See DTC INSPECTION.) • Are any DTCs detected?	Yes	Go to applicable DTC inspection. (See DTC TABLE.)
1		No	Go to the next step.
2	VERIFY THAT THE SAME DTC IS NOT PRESENT • Reconnect all disconnected connectors. • Clear the DTCs from the memory. (See ON-BOARD DIAGNOSIS [ANTILOCK BRAKE SYSTEM (ABS)].) • Start the engine and drive the vehicle at 10 km/h {6.2 mph} or more. • Are the same DTCs present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the ABS HU/CM, then go to the next step. (See ABS HU/CM REMOVAL/INSTALLATION.)
2		No	Go to the next step.
3	VERIFY THAT NO OTHER DTCS ARE PRESENT • Are any other DTCs output?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSIS [ANTILOCK BRAKE SYSTEM (ABS)].)
3		No	DTC troubleshooting completed.

DTC	C0062:28, C0062:64		SAS control module system
DETECTION CONDITION		Note • The low-G sensor and the yaw rate sensor are built into the SAS control module. • Out-of-specification signal modulation or longitudinal-G value is detected from the low-G sensor.
FAIL-SAFE FUNCTION		Not applicable
POSSIBLE CAUSE		• SAS control module malfunction • ABS HU/CM malfunction • Poor connection at connectors (female terminal)
SYSTEM WIRING DIAGRAM		Not applicable