|
1
|
INSPECT POWER OUTER MIRROR (LH) CONNECTOR CONDITION
• Switch the ignition off.
• Disconnect the negative battery cable.
• Disconnect the power outer mirror (LH) connector.
• Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection.
• Is the connector normal?
|
Yes
|
Go to the next step.
|
|
No
|
Repair or replace the connector, then go to Step 6.
|
|
2
|
INSPECT BSM CONTROL MODULE (LH) CONNECTOR CONDITION
• Disconnect the BSM control module (LH) connector.
• Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection.
• Is the connector normal?
|
Yes
|
Go to the next step.
|
|
No
|
Repair or replace the connector, then go to Step 6.
|
|
3
|
INSPECT FOR SHORT TO GROUND IN BSM INDICATOR LIGHT (LH) CIRCUIT
• Verify that the BSM control module (LH) and power outer mirror (LH) connectors are disconnected.
• Inspect for continuity between power outer mirror (LH) terminal D (wiring harness-side) and body ground.
• Is there continuity?
|
Yes
|
Refer to the wiring diagram and verify whether or not there is a common connector between BSM control module (LH) terminal G and power outer mirror (LH) terminal D.
If there is a common connector:
• Determine the malfunctioning part by inspecting the common connector and the terminal for corrosion, damage, or pin disconnection, and the common wiring harness for a short to ground.
• Repair or replace the malfunctioning part.
If there is no common connector:
• Repair or replace the wiring harness which has a short to ground.
Go to Step 6.
|
|
No
|
Go to the next step.
|
|
4
|
INSPECT POWER OUTER MIRROR (LH)
• Inspect the power outer mirror (LH).
• Is the power outer mirror (LH) normal?
|
Yes
|
Go to the next step.
|
|
No
|
Replace the power outer mirror (LH), then go to Step 6.
|
|
5
|
INSPECT BSM INDICATOR LIGHT (LH)
• Inspect the BSM indicator light (LH).
• Is the BSM indicator light (LH) normal?
|
Yes
|
Go to the next step.
|
|
No
|
Replace the outer mirror glass (LH), then go to the next step.
|
|
6
|
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
• Always reconnect all disconnected connectors.
• Reconnect the negative battery cable.
• Clear the BSM control module (LH) DTCs using the M-MDS.
• Retrieve the BSM control module (LH) DTCs using the M-MDS.
• Is the same DTC displayed?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the BSM control module (LH).
Go to the next step.
|
|
No
|
Go to the next step.
|
|
7
|
VERIFY IF OTHER DTCs DISPLAYED
• Are any other DTCs displayed?
|
Yes
|
Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
|
|
No
|
DTC troubleshooting completed.
|
