DTC U0515:68 [REAR VEHICLE MONITORING SYSTEM]

id0902z2842200

Description

Error signal received from start stop unit

Detection condition

•  Rear vehicle monitoring control module (LH) receives the error signal from the start stop unit for 2 s or more.

Fail-safe function

•  Inhibits the rear vehicle monitoring system.

Possible cause

•  DTCs are stored in the start stop unit.

•  DTCs are stored in the instrument cluster.

•  Instrument cluster malfunction

•  Start stop unit malfunction

•  Rear vehicle monitoring control module (LH) malfunction

System wiring diagram

Not applicable

Description	Error signal received from start stop unit
Detection condition	• Rear vehicle monitoring control module (LH) receives the error signal from the start stop unit for 2 s or more.
Fail-safe function	• Inhibits the rear vehicle monitoring system.
Possible cause	• DTCs are stored in the start stop unit. • DTCs are stored in the instrument cluster. • Instrument cluster malfunction • Start stop unit malfunction • Rear vehicle monitoring control module (LH) malfunction
System wiring diagram	Not applicable

Diagnostic Procedure

Step	Inspection		Action
1	VERIFY START STOP UNIT DTCs • Retrieve the start stop unit DTCs using the M-MDS. (See DTC INSPECTION [START STOP UNIT].) • Are any DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [START STOP UNIT].)
1		No	Go to the next step.
2	VERIFY INSTRUMENT CLUSTER DTCs • Retrieve the instrument cluster DTCs using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER].) • Are any DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [INSTRUMENT CLUSTER].)
2		No	Go to the next step.
3	INSPECT INSTRUMENT CLUSTER • Inspect the instrument cluster. (See INSTRUMENT CLUSTER INSPECTION.) • Is the instrument cluster normal?	Yes	Go to the next step.
3		No	Replace the instrument cluster, then go to Step 5. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)
4	PERFORM DTC INSPECTION AND VERIFY START STOP UNIT MALFUNCTION • Clear the DTC for the rear vehicle monitoring control module using the M-MDS. (See CLEARING DTC [REAR VEHICLE MONITORING SYSTEM].) • Switch the ignition ON (engine off or on) and wait for 3.5 s or more. • Retrieve the rear vehicle monitoring control module DTCs using the M-MDS. (See DTC INSPECTION [REAR VEHICLE MONITORING SYSTEM].) • Is the same DTC displayed?	Yes	Replace the start stop unit, then go to the next step. (See START STOP UNIT REMOVAL/INSTALLATION.)
4		No	Go to Step 6.
5	VERIFY THAT REPAIRS HAVE BEEN COMPLETED • Clear the DTC for the rear vehicle monitoring control module using the M-MDS. (See CLEARING DTC [REAR VEHICLE MONITORING SYSTEM].) • Switch the ignition ON (engine off or on) and wait for 3.5 s or more. • Retrieve the rear vehicle monitoring control module DTCs using the M-MDS. (See DTC INSPECTION [REAR VEHICLE MONITORING SYSTEM].) • Is the same DTC displayed?	Yes	Repeat the inspection from Step 1. • If the malfunction recurs, replace the rear vehicle monitoring control module (LH). (See REAR VEHICLE MONITORING CONTROL MODULE REMOVAL/INSTALLATION.) Go to the next step.
5		No	Go to the next step.
6	VERIFY IF OTHER DTCs DISPLAYED • Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [REAR VEHICLE MONITORING SYSTEM].)
6		No	DTC troubleshooting completed.