ANTENNA FEEDER NO.2 INSPECTION
id092000812500
4SD
1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [MZR 1.6].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 1.5, SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)(See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 1.5].)
2. Remove the A-pillar trim (RH). (See A-PILLAR TRIM REMOVAL/INSTALLATION.)
3. Remove the C-pillar trim (RH). (See C-PILLAR TRIM REMOVAL/INSTALLATION.)
4. Disconnect antenna feeder No.1.
|
5. Disconnect antenna amplifier.
|
6. Verify that the continuity between antenna feeder No.2 terminals is as indicated in the table.
|
|
5HB
1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [MZR 1.6].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 1.5, SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)(See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 1.5].)
2. Remove the following parts:
3. Set the tire house trim aside. (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)
4. Remove the trunk side upper trim. (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION.)
5. Remove the C-pillar trim. (See C-PILLAR TRIM REMOVAL/INSTALLATION.)
6. Disconnect antenna feeder No.1.
|
7. Disconnect antenna feeder No.3.
|
8. Verify that the continuity between antenna feeder No.2 terminals is as indicated in the table.
|
|