ANTENNA FEEDER NO.3 INSPECTION

id092000813000

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [MZR 1.6].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 1.5, SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)(See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 1.5].)

2.  Remove the following parts:

(1)  Rear package tray (See REAR PACKAGE TRAY REMOVAL/INSTALLATION.)

(2)  Trunk covering (See TRUNK COVERING REMOVAL/INSTALLATION.)

(3)  Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)

3.  Set the tire house trim aside. (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)

4.  Remove the following parts:

(1)  Trunk side upper trim (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION.)

(2)  C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION.)

(3)  Rear assist handle (See ASSIST HANDLE REMOVAL/INSTALLATION.)

5.  Partially peel back the headliner.

Note

•  If the headliner is peeled back excessively, the headliner could become creased. Be careful not to peel back the headliner excessively.

6.  Disconnect antenna feeder No.2.

7.  Disconnect the center roof antenna connector.

8.  Verify that the continuity between antenna feeder No.3 terminals is as indicated in the table.

am3zzw00015964

am3zzw00015965

•  If not as indicated in the table, replace antenna feeder No.3.