DTC U3003:17 [ADAPTIVE FRONT LIGHTING SYSTEM (AFS)]
id09021n935300
Description |
AFS control module high power supply voltage input |
---|---|
Detection condition
|
• AFS control module power supply circuit voltage of 18.1 V or more is detected for 5 s or more with the ignition switched ON (engine off or on).
|
Fail-safe function
|
• The swivel actuator is stopped at the position when the malfunction is determined.
• The headlight leveling actuator is stopped at the position when the malfunction is determined.
|
Possible cause
|
• DTCs are stored in the PCM.
• Battery malfunction
• Generator malfunction
• AFS control module malfunction
|
System wiring diagram
|
Not applicable
|
Diagnostic Procedure
Step |
Inspection |
Action |
|
---|---|---|---|
1
|
VERIFY PCM DTCs
• Retrieve the PCM DTCs using the M-MDS.
• Are any DTCs displayed?
|
Yes
|
Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [SKYACTIV-D 1.5].)
(See DTC TABLE [SKYACTIV-D 2.2].)
(See DTC TABLE [MZR 1.6].)
|
No
|
Go to the next step.
|
||
2
|
INSPECT BATTERY
• Inspect the battery.
(See BATTERY INSPECTION [MZR 1.6].)
• Is the battery normal?
|
Yes
|
Go to the next step.
|
No
|
Replace the battery, then go to Step 4.
|
||
3
|
INSPECT GENERATOR
• Inspect the generator.
• Is the generator normal?
|
Yes
|
Go to the next step.
|
No
|
Replace the generator, then go to the next step.
(See GENERATOR REMOVAL/INSTALLATION [SKYACTIV-G 1.5, SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-ELOOP)].)
|
||
4
|
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
• Clear the DTC for the AFS control module using the M-MDS.
• Switch the ignition ON (engine off or on) and wait for 5 s or more.
• Retrieve the AFS control module DTCs using the M-MDS.
• Is the same DTC displayed?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the AFS control module, then go to the next step.
|
No
|
Go to the next step.
|
||
5
|
VERIFY IF OTHER DTCs DISPLAYED
• Are any other DTCs displayed?
|
Yes
|
Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
|
No
|
DTC troubleshooting completed.
|