DTC U1A4B:17 [REAR VEHICLE MONITORING SYSTEM]


id0902z2888500

Description

Rear vehicle monitoring control module (RH) high power supply voltage input

Detection condition
•  Rear vehicle monitoring control module (RH) power supply circuit voltage of 16 V or more is detected for 1 s or more.
Fail-safe function
•  Inhibits the rear vehicle monitoring system.
Possible cause
•  DTCs are stored in the PCM.
•  Battery malfunction
•  Generator malfunction
•  Rear vehicle monitoring control module (RH) malfunction
System wiring diagram
Not applicable

Diagnostic Procedure

Step

Inspection

Action

1
VERIFY PCM DTCs
•  Are any DTCs displayed?
Yes
Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
No
Go to the next step.
2
INSPECT BATTERY
•  Is the battery normal?
Yes
Go to the next step.
No
Replace the battery, then go to Step 4.
3
INSPECT GENERATOR
•  Is the generator normal?
Yes
Go to the next step.
No
Replace the generator, then go to the next step.
4
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
•  Clear the DTC for the rear vehicle monitoring control module using the M-MDS.
•  Switch the ignition ON (engine off or on) and wait for 2.5 s or more.
•  Retrieve the rear vehicle monitoring control module DTCs using the M-MDS.
•  Is the same DTC displayed?
Yes
Repeat the inspection from Step 1.
•  If the malfunction recurs, replace the rear vehicle monitoring control module (RH).
Go to the next step.
No
Go to the next step.
5
VERIFY IF OTHER DTCs DISPLAYED
•  Are any other DTCs displayed?
Yes
Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
No
DTC troubleshooting completed.